Power UNITS FOR LIFT TABLE one
General Description
This power unit is built exclusively to the smaller lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit continues to be widely used from the industry of logistic devices including minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed through the solenoid valve together with the speed controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is built solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and the velocity managed by the adjustable needle valve. Once the lift rises to a substantial positoin, but the power provide is cut, the reducing motion is controlled by the manual override perform.
Energy UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is developed solely for that significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace controlled by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is intended exclusively for your large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the speed controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power supply is reduce, the decreasing motion is controlled through the manual override perform.
Particular Notes
one. This energy unit is of S3 duty cycle, which may only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned prior to installation of the power unit.
3. Viscosity with the oil shoud be 15~46 cst,which really should also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
four. Oil altering is needed following the first 100 operation hours,afterwards once every 3000 hrs.
5. The power unit proven is made to be mounted vertically.