Material Dealing with Power UNIT 1
General Description
This power unit is intended for your fork lift market, consisting of extremely effective gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down motion are controlled through the lever from the manual release valve, which can be outfitted with an electrical switch to activate the motor. The lowing speed is controlled by the strain compensated flow manage valve.
Distinctive Notes
1. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic parts concerned ahead of set up of the energy unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should also be clean and totally free of impurities, N46 hydraulic oil is suggested .
four. Oil shifting is needed soon after the initial one hundred operation hours, afterwards the moment each and every 3000 hrs.
five. The energy unit proven is built to be mounted horizontally.

Materials Managing Power UNIT 2
General Description
This electrical power unit functions electrical power up gravity down circuit. Activate the start off solenoid to begin the motor to lift the machine. The lowing movement is activated through the solenoid valve using the lowering velocity controlled from the pressure compensated flow management valve. Solutions of this series could be extensively utilized in the market of logistic units like fork lift, mini lift table, and so forth.
Special Notes
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic parts concerned ahead of mounting the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which need to also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil shifting is needed immediately after the preliminary a hundred operation hours,afterwards after each and every 3000 hrs.
five. The power unit need to be mounted horizontally.