SMR Gearbox Installation
Satisfactory efficiency will depend on proper set up. lubrication and upkeep. therefore it is vital that the instructions from the installation and servicing leaflet. provided with every gearbox. are followed thoroughly. some of the vital aspects of belt and torque-arm installation are listed beneath.
1. Install pulley on gearbox input shaft as near towards the reducer feasible, and mount reducer on driven shaft as near to bearing as useful. failure to do this can trigger extra loads during the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive using the belt pull at approximately 90° for the center line amongst driven and input shafts. this can allow tensioning of the wedge belt drive using the torque arm which ought to preferably be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the ideal.
3. lnstall torque-arm fulcrum on the rigid help to ensure the torque-arm will probably be at roughly proper angles towards the center line with the driven shaft as well as torque arm situation bolt. be sure there is sufficient consider up within the turnbuckle for belt tension adjustment.
Hold near.
Bell drive may be situated in any effortless postion. should the torque arm is always to be utilised to tighten the belts, the drive really should be at about tight angle towards the line involving the input and output shafts.
Bell drive might be found to the appropriate if desired.
If output hub rotates clock-wise. position belt drive and torque arm in opposite direction to that proven within the illustration.
Torque arm and belt get up.
Torque arm could be mounted for the suitable if wanted.