C and CFR Style Functionality Information

C Form Flex-Flex Couplings
The C Variety coupling consists of two flex hubs, one sleeve and one accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Type coupling include a single flex hub, one particular rigid hub, 1 sleeve, one particular accessory kit consisting of seals and snap rings.
Capabilities
Very simple and inexpensive type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Obtainable as vertical and horizontal couplings
Broad selection of unique variations like full-flex, flex-rigid mill motor
Conventional configurations are available from the shelf
Ordering Information and facts
Application: Driver and Driven.
Kind and size of coupling, horizontal, vertical etc.
Power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Facts
Puller Holes are standard on sizes four through twelve.
Puller Holes can be found for sizes 7/8 by means of 3.5 at an extra charge.
The BSE (distance In between Shaft Ends) might fluctuate between G and G1.
Interference bores without any set screws are typical unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, talk to Engineering Part.
Larger sizes can be found, please check with Technical Help.